Fuel Injection Pump - Remove (Delphi Dp210) - Perkins 1103 Disassembly And Assembly

SENR9779-02
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: The installation procedure is identical for the
four cylinder and the three cylinder engines. The
illustration shows the four cylinder engine.
Illustration 15
Typical example
1. Thoroughly clean all of the inner surfaces of the
cover (1) for the fuel injectors.
2. Install the cover (1).
3. Install the setscrews (2) for the cover (1). Tighten
the setscrews (2) to a torque of 9 N·m (7 lb ft).
Fuel Injection Pump - Remove
(Delphi DP210)
Removal Procedure
Start By:
a. Remove the fuel injection lines. Refer to this
Disassembly and Assembly Manual, "Fuel
Injection Lines - Remove".
g01011111
b. Remove the crankshaft pulley. Refer to this
Disassembly and Assembly Manual, "Crankshaft
Pulley - Remove and Install".
c. Remove the front cover. Refer to this Disassembly
and Assembly Manual, "Front Cover - Remove
and Install".
Note: The removal procedure is identical for the
four cylinder and the three cylinder engines. The
illustrations show the four cylinder engine.
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the No. 1 cylinder is at top dead
center on the compression stroke. Refer to the
Testing and Adjusting Manual, "Finding Top Center
Position for No. 1 Piston".
Disassembly and Assembly Section
NOTICE
11
i02216956