Turbocharger - Remove - Perkins 1103 Disassembly And Assembly

SENR9779-02

Turbocharger - Remove

Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
Note: The removal procedure is identical for the
three cylinder and the four cylinder engines.
1. Thoroughly clean the outer surfaces of the
turbocharger (1).
2. Loosen the hose clamps and remove the air inlet
hose at the turbocharger compressor housing.
Note: Exhaust elbows are only an option for the four
cylinder engines.
3. Remove the exhaust pipe from the turbocharger
outlet or remove the exhaust pipe from the exhaust
elbow. Refer to the OEM provided information
for the correct procedure in order to remove the
exhaust pipe.
i01944022
Illustration 57
Typical example
4. If an exhaust elbow is installed, remove the
exhaust elbow. Refer to this Disassembly and
Assembly Manual, "Exhaust Elbow - Remove and
Install".
5. Remove the nuts (2) and remove the exhaust
adapter (3) from the turbocharger (1).
6. Place a suitable container below the turbocharger
(1) in order to collect any spillage of oil.
Illustration 58
Typical example
Disassembly and Assembly Section
29
g01038600
g01038396