Fan Drive - Remove And Install - Perkins 1103 Disassembly And Assembly

SENR9779-02
Illustration 291
Typical example
1. Remove the setscrews (1).
2. Remove the fan.
3. If equipped, remove the extension for the fan.
4. Remove the fan pulley.
Installation Procedure
Note: The installation procedure is identical for the
three cylinder and the four cylinder engines. The
illustration shows the four cylinder engine.
1. Inspect the condition of the fan pulley. Replace the
fan pulley, if necessary.
2. Install the fan pulley.
3. If the engine is equipped with an extension for the
fan, install the extension.
4. Inspect the condition of the fan and replace the
fan, if necessary.
5. Install the fan.
Illustration 292
Typical example
6. Install the setscrews (1). Tighten the setscrews (1)
to a torque of 12 N·m (9 lb ft).
End By:
a. Install the V-Belts. Refer to this Disassembly and
Assembly Manual, "V-Belts - Remove and Install".

Fan Drive - Remove and Install

Removal Procedure
g00926178
Start By:
a. Remove the fan. Refer to this Disassembly and
Assembly Manual, "Fan - Remove and Install".
Illustration 293
1. Remove the setscrews (1) from the fan drive (2).
2. Remove the fan drive (2).
Installation Procedure
Illustration 294
g00926178
1. Install the fan drive (2).
Disassembly and Assembly Section
129
i02011983
g00944500
g00944500