Fuel Injector Cover - Remove And Install (If Equipped) - Perkins 1103 Disassembly And Assembly

10
Disassembly and Assembly Section
Illustration 13
Typical example
1. Inspect the fuel injection lines (1) for wear and for
damage. Replace any fuel injection line (1) that is
worn or any fuel injection line that is damaged.
2. Loosely install the clamps for the fuel injection
lines (1).
3. Remove the dust caps from the fuel injection
pump (3) and from the fuel injectors (2). Remove
the dust caps from the fuel injection lines (1).
4. Loosely connect the nuts at both ends of the fuel
injection lines (1).
5. Ensure that each fuel injection line (1) does not
contact any other fuel injection line or any other
engine component. Tighten the fasteners for the
clamps for the fuel injection lines (1). Check that
the fuel injection lines (1) are still clear of other
components.
6. Tighten the fuel injection lines (1) at the fuel
injectors (2) to a torque of 30 N·m (22 lb ft).
7. Tighten the fuel injection lines (1) at the fuel
injection pump (3) to 30 N·m (22 lb ft).
8. Remove the air from the fuel system. Refer to
the Operations and Maintenance Manual, "Fuel
System - Prime".
End By:
a. If equipped, install the cover for the fuel injectors.
Refer to this Disassembly and Assembly Manual,
"Fuel Injector Cover - Remove and Install".
Fuel Injector Cover - Remove
and Install
(If Equipped)
g00955826
Removal Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: The removal procedure is identical for the
four cylinder and the three cylinder engines. The
illustration shows the four cylinder engine.
Illustration 14
Typical example
1. Thoroughly clean all of the outer surfaces of the
cover (1) for the fuel injectors.
2. Remove the setscrews (2) from the cover (1).
3. Remove the cover (1).
SENR9779-02
i02221380
NOTICE
g01011111