Fuel Injection Lines - Remove; Fuel Injection Lines - Install - Perkins 1103 Disassembly And Assembly

SENR9779-02
4. Install the spin-on filter (3) onto the filter head (5).
5. Tighten the spin-on filter by hand until the sealing
ring contacts the filter head. Rotate the spin-on
filter through 90 degrees.
6. Close the drain (1).
7. Prime the fuel system. Refer to Operation and
Maintenance Manual, "Fuel System - Prime".

Fuel Injection Lines - Remove

Removal Procedure
Start By:
a. If equipped, remove the cover for the fuel injectors.
Refer to this Disassembly and Assembly Manual,
"Fuel Injector Cover - Remove and Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
Note: The removal procedure is identical for four
cylinder and three cylinder engines. The illustration
shows the four cylinder engine.
i02221357
Illustration 12
Typical example
1. Disconnect the fuel injection lines (1) at the fuel
injectors (2).
2. Disconnect the fuel injection lines (1) at the fuel
injection pump (3).
3. If it is necessary remove the clamps for the fuel
injection lines or loosen the clamps for the fuel
injection lines. Remove the fuel injection lines (1).
4. Install dust caps onto the ports of the fuel injectors
and onto the ports of the fuel injection pump. Install
dust caps onto both ends of the fuel injection lines.

Fuel Injection Lines - Install

Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
Note: The installation procedure is identical for the
four cylinder and the three cylinder engines. The
illustration shows the four cylinder engine.
Disassembly and Assembly Section
NOTICE
NOTICE
9
g00955826
i02221359