Perkins 1103 Disassembly And Assembly page 25

SENR9779-02
5. Position the fuel injection pump gear (8) onto the
shaft of the fuel injection pump. Install the washer
and the nut (7). Rotate the fuel injection pump
gear (8) in a counterclockwise direction in order
to remove the backlash. Tighten the nut (7) to a
torque of 24 N·m (17 lb ft).
Illustration 48
6. Connect the wiring harness assembly to the
engine shutoff solenoid (4).
7. Connect the wiring harness assembly to the cold
start advance unit (3).
8. Remove all of the dust caps from the connectors
on the fuel injection pump. Remove all of the plugs
from the fuel hose assemblies and from the tube
assemblies.
9. Connect the tube assembly (2) to the fuel injection
pump. Connect the tube assembly (1) to the fuel
injection pump.
Illustration 49
10. Loosen the locking screw (6). Move spacer (5)
in order to prevent the locking screw (6) from
tightening against the shaft of the fuel injection
pump. Tighten the locking screw (6) to a torque of
12 N·m (106 lb in).
Note: The spacer (5) must be installed and the
locking screw (6) must be tightened in order to
prevent the locking screw from contacting the shaft
of the fuel injection pump.
Illustration 50
11. Tighten the nut (7) to a torque of 88 N·m (65 lb ft).
g00996409
End By:
a. Install the front cover. Refer to this Disassembly
and Assembly Manual, "Front Cover - Remove
and Install".
b. Install the crankshaft pulley. Refer to this
Disassembly and Assembly Manual, "Crankshaft
Pulley - Remove and Install".
c. Install the fuel injection lines. Refer to this
Disassembly and Assembly Manual, "Fuel
Injection Lines - Install".
g00996410
Disassembly and Assembly Section
25
g01011474