I Am Having Problems Getting A Pptp Connection - NetComm NTC-790 User Manual

I am having problems getting a PPTP connection.

11.2.9
Check the routes on the "Routing" page
There should be 5 routes shown.
•
One route for interface eth0.
•
Two routes for interface ppp0.
•
Two routes for interface ppp1.
If there are not 5 routes it is most possible:-
•
PPTP is not enabled.
•
The credentials on the PPTP HTML page are wrong, either the IP address or username, password.
Check the logfile:
•
If you see the message: "The synchronous PPTP option is NOT activated" or "CHAP Authentication
Failure" then the credentials are incorrect.
Revision 1.55
March 2009
63
NetComm Limited