NetComm NTC-790 User Manual page 45

st
For UDP the 1
immediately after the ID; for TCP the ID is transmitted once immediately after the connection is established.
Ignore String
When the "Ignore String" field is not blank (empty) the router will strip any character sequence that
matches the "Ignore String" from the data stream received from the serial port.
Connect To
Determines how the router behaves when it receives an "ATD" command on the serial port.
•
Profile
•
Circuit
•
Packet
•
DialString
DTR Action
Determines how the router responds to change of state of the serial port DTR line
•
Ignore
•
Command
•
Hangup
•
High AutoDial
•
Low AutoDial
•
Low Pass To ATPort
DCD Action
Determines how the router controls the state of the serial port DCD line
•
Always On
•
Connect On
Revision 1.55
March 2009
<n> bytes of each datagram sent will be set to the contents of the ID field, data follows
Connect using "Data Connection Profile"
Establish a circuit switched data connection
Connect to cellular packet network in PPP pass through mode
Examine the dialed digits and connect to Profile, Circuit or Packet as appropriate
Take no action
High to Low transition of DTR causes the router to enter command mode
(does not end call)
High to Low transition of DTR causes the router to end call and enter
command mode
Low to High transition of DTR causes the router to dial the Auto Dial
Number, High to Low transition of DTR causes the router to end call and
enter command mode
High to Low transition of DTR causes the router to dial the Auto Dial
Number, Low to High transition of DTR causes the router to end call and
enter command mode
When DTR is low pass all AT commands directly to internal cellular data
engine.
DCD is always on
DCD is on when a connection is established in response to an ATD command or
DTR auto dial.
44
NetComm Limited