Gas Conversion - Bradford White Brute BNTH Installation And Operation Instructions Manual

Brute
BOILERS AND VOLUME WATER HEATERS
NOTE: The Warranty does not cover damage caused
by lack of required maintenance, lack of water flow,
or improper operating practices.
Failure to rinse the debris from the heat exchanger
and temporary drain line may lead to clogged
condensate lines, traps and neutralizers. Condensate
pumps (if used) may also be damaged by the debris
left behind, possibly causing property damage.
11. Install all components removed in the reverse
order to place the appliance back in operation. Be
sure all gaskets are in place as the components
are installed. Replace any damaged gaskets. Do
not reuse damaged gaskets.
12. Place the appliance in operation according to
the instructions in Section 10. Check all gas
connections for leaks. Confirm that all fasteners
are tight.
Optional Gas Pressure Switches
The high and low gas pressure switches are 24V
manual reset switches that act to cut power to the gas
valves if the gas pressure is too low or too high for
proper operation. The gas pressure switches used are
integrally vent limited, and do not require venting to
atmosphere. To remove a switch, remove the screw
on the plastic housing and pull the clear cover off.
Disconnect the two wires from the screw terminals.
Twist the switch off the pipe nipple. Reassemble in
reverse order. For natural gas, set the low gas pressure
switch to 3" w.c. For propane, set the low gas pressure
WARNING
BNT size (mbtu)
150
199
210
285
399
500
600
750
850
Table 16a - Propane Gas Conversion Kits
BNT size (mbtu)
150
199
210
285
399
500
600
750
850
Table 16b - Natural Gas Conversion Kits
Page 59
Kit number
CA006203
CA006204
CA006204
CA006205
CA008600
CA008600
CA008600
CA008600
CA008600
Kit number
CA006206
CA006206
CA006206
CA006206
CA008600
CA008600
CA008600
CA008600
CA008600