Bradford White Brute BNTH Installation And Operation Instructions Manual page 41

Brute
BOILERS AND VOLUME WATER HEATERS
Menu 7. Safety Parameter Confirmation
5. For each group, check the list carefully. Press
Yes if all of the parameters in the group have
been entered correctly. For each group, you are
given 30 seconds to select Yes/No.
A count-down timer is shown at the bottom of
the screen.
If you made changes in other safety-related
groups, verify the entries in those groups in the
same way. Do this until the following screen
shows
Menu 8. Safety Parameter Reset
6. When the process is complete, the system will
tell you to reset the control system. The Reset
button is located on the front of the controller.
You must press the Reset button within 30
seconds, or the verification will be cancelled. A
count-down timer is shown at the bottom of the
screen.
8.4 Checking Individual Parameters
1. From the 'Home' screen (Menu 9), press the
icon for the controller.
Menu 9. 'Home' screen
2. The Status Summary page for the controller
will appear. This shows the current operating
condition of the controller, and also shows some
of the configuration settings.
See Menu 10
Menu 10. Status Summary Screen
Notice the four buttons at the bottom of each
Status Summary screen:
• Configure – Allows an installer to change
some of the setup parameters used by the
system. A password may be required.
• Operation – Used to adjust the setpoints,
change the fan speed, turn a burner on or off,
or turn the pumps on or off.
• Diagnostics – Allows you to run diagnostic
tests, or check the inputs and outputs used by
the system.
• Details – Allows you to check the status of all
of the setup parameters on the control system.
Page 37