Bradford White Brute BNTH Installation And Operation Instructions Manual page 75

Brute
BOILERS AND VOLUME WATER HEATERS
203 Invalid MFEP
(Main Flame
Establishing
Period) fl ame
failure response
setting
204 Invalid NTC
sensor type
setting
205 Invalid Outlet
high limit
response setting
207 Invalid PII
(Pre-Ignition
Interlock) enable
setting
210 Invalid
Postpurge time
setting
211 Invalid Power
up with lockout
setting
212 Invalid
Preignition time
setting
213 Invalid Prepurge
rate setting
214 Invalid Prepurge
time setting
215 Invalid Purge
rate proving
setting
216 Invalid Run
fl ame failure
response setting
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L 1. Return to Confi guration mode and recheck selected parameters,
reverify and reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
Page 71