Bradford White Brute BNTH Installation And Operation Instructions Manual page 33

Brute
BOILERS AND VOLUME WATER HEATERS
WARNING: This drawing shows
suggested piping configuration and
valving. Check with local codes and
ordinances for additional requirements.
Figure 25. DHW Piping, Two Heaters, One Vertical Tank
NOTES:
1. Optional CWMU & Recirc.
line location.
2. Locate BNTV DHW sensor
or remote aquastat well
in lower 1/3 of tank.
3. Back flow preventer may be
required - check local codes.
4. Thermal expansion tank may be
required - check local codes.
5. Factory mounted pumps are sized
for a max pipe length of 30' total,
6-90° elbows, full pipe size.
6. Caution: Pump sizing must
be based on water
hardness at job site.
Figure 26. DHW Piping, Two Heaters, Two Vertical Tanks
NOTES:
1. Optional CWMU & Recirc. line location.
2. Locate BNTV DHW sensor or remote aquastat
well in lower 1/3 of tank.
3. Back flow preventer may be required - check
local codes.
4. Thermal expansion tank may be required -
check local codes.
5. Factory mounted pumps are sized for a max
pipe length of 30' total, 6-90° elbows, full pipe size.
6. Caution: Pump sizing must be based on
water hardness at job site.
WARNING: This drawing shows
suggested piping configuration and
valving. Check with local codes and
ordinances for additional requirements.
Page 29