Gas Conversion Instructions - Bradford White RG2DVMH40T6X-264 Manual

Gas Conversion Instructions

Unless specifically ordered for operation on natural gas, this water heater is
normally equipped for operation on liquefied petroleum (LP) gas but may be
converted by following these gas conversion instructions.
Caution: Make sure gas to be supplied to this water heater following the
conversion matches the gas being converted to.
All gas conversions must be performed by qualified service personnel only.
To convert from LP gas to natural gas
(For control shown in Figure 6 only)
1. Depress and rotate gas control knob clockwise
2. Change main gas regulator by removing cap from gas regulator. Depress
and rotate knob clockwise
Replace cap.
Figure 6
3. Change the pilot regulator by removing pilot regulator cap. Depress and
rotate knob counterclockwise
Replace cap.
4. Remove the outer door. Remove, or slide open, the inner door.
5. Disconnect thermocouple, gas supply tube and pilot tube from the gas valve
and remove the burner assembly from the water heater.
6. Remove the "RED" color coded L.P. orifice and pilot assembly and replace
with natural gas orifice and pilot assembly provided in the cloth bag attached
to the water heater.
CAUTION
to NAT. setting using a screwdriver.
to the NAT. setting using a screwdriver.
16
to the "OFF" position.