Setting Min. Density Level - Sekonic SR-3500 Operating Manual

■ Setting min. density level

You can set the min. density level for this device when it is in SR-600/SR-9000 operating
mode. Sensitivity levels range from 1 to 16, with level 1 being the maximum sensitivity and
level 16 the lowest sensitivity.
MENU
1. Press the
UP
2. Use the and
and press the
UP
3. Use the and
and press the
*
(" " mark flashes in the first column of the first line on the LCD.)
MENU
4. Use the and
FEED/ENTER
5. Press the
(The flashing "
6. Keep pressing the
or press the
SR-3500
SR-6500
min. density
min. density
level
1
2
3
4
5
6
*1. The above sensitivity level is a standard table under a complete marked
mark of grid width for 3mm in 105g/m2 paper thickness.
*2. The sensitivity level varies depending on marks because reading method is
different each other.
*3. When you use this device in compatible mode, the verification by you is
necessary .
Data reading settings ■ Setting min. density level
switch to enter the menu mode.
DOWN
switches to select the following parameters,
FEED/ENTER
switch.
DOWN
switches to select [Min. Density Level] setting,
FEED/ENTER
switch.
DOWN
switches to set the value.
switch to save the setting value into memory.
*
" mark disappears from the LCD.)
CLEAR/EXIT
switch until it returns to normal mode,
MENU
switch to return to normal mode.
SR-600 SR-600
SR-3500
SR-9000 SR-9000
SR-6500
mode mode
min. density
min. density
level
level level
1 7 5~6
1~2 8 6~7
2~3 9 7~8
3~4 10 8~9
4~5 11 9~10
5~6
Min. density level
setting values
1 - 16
SR-600
SR-3500
SR-9000
SR-6500
mode
min. density
min. density
level
level
12 10~11
13 10~11
14 11~12
15 12~13
16 13~14
-41-