Sekonic SR-3500 Operating Manual page 27

Note)
1) The aligning roller is fixed with the magnet.Check that there is not
a gap and a floating on the adsorption aspect. In case of a certain
pressing the panel side, make stick.
2) Because the aliging roller section has used the magnet, do not bring
close a floppy disk and magnetic card etc...
Aligning roller
3.
To see the maximum number of cards that can be loaded into the hopper, refer to
the side guide index. (A maximum of 500 sheets of 105g/m2 weight paper.) Note
that overloading may result in paper not feeding, or in reading errors.
Notes)
1) Carefully handle paper so that it is not bent or damaged. If bent or
damaged sheets are used, paper may not feed or reading errors may
occur.
2) Do not use paper in any of the following states:
Soiled or damaged paper, paper to which dust or other foreign matter
adheres, curled paper or folded paper (folded in two, four, etc.)
3) When adding paper, lower the hopper and be sure to reset the paper.
Be sure to loosen the sheets as shown in the left figure so as to
prevent double feeding when sheets adhere to each other.
4) When storing paper, avoid keeping it in a place subject to sudden
environmental changes. Pay thorough attention to moisture and keep
paper in a cabinet or other safe place. Do not leave paper in a dusty
place such as near a window.
Operation ■ Loading paper
-27-