Connecting To A Computer ■ Usb - Sekonic SR-3500 Operating Manual

Connecting to a computer
Connecting to a computer
This device is equipped with USB and RS-232C interfaces.When connecting the OMR,the
connection with USB in order to show the performance of this device sufficiently is
recommended. When connecting using USB, use the USB driver inside CR-ROM that came
with this device.
When replacing the OMR SR-600,SR-9000 series with this device, you can use the RS-232C
interface. ※ 1
When using the RS-232C interface, set the same communication setting on this device and
the computer.
Set the computer communication setting by checking your computer or software manuals.
※ 1 ) There are times when it does not operate normally due to the environment of use.
See the following pages to set the communication setting for this device.
USB
Operating mode → select
Interface setting (device ID setting) ............................... P.32
• See P.31 and later when using USB.
RS-232C
Operating mode → select
Interface settings
Setting baud rate ..................................................... P.34
Setting cheracter bit length ...................................... P.34
Setting parity ............................................................ P.35
Setting stop bit ......................................................... P.36
Setting flow control .................................................. P.36
Setting character code ............................................. P.37
• See P.33 and later when using RS-232C.
* SR-700 series can operate in SR-600 mode.
Note)
*
Responding time to resetting command(CAN command) which is
stated in the operating manual of SR-600, SR-9000 series
Time after this device receiving resetting command(CAN command) ,it
return ACK code is maximum approximately 5.6 seconds.
*
As for the details of commands of SR-600 mode please see the
operating manual of SR-600
*
As for the details of commands of SR-9000 mode please see the
operating manual of SR-9000
-30-
(
SR-3500
mode ................... P.31
SR-6500
(
SR-600
mode ................... P.33
SR-9000