Loading Paper - Sekonic SR-3500 Operating Manual

Operation ■ Loading paper

■ Loading paper

1.
Load paper with the timing marks on the left side of the hopper. The hopper is
set to drop when the power is turned on, but if it's still raised, press the DOWN
switch in normal mode to lower the hopper. At this time, align paper carefully. Pay
particular attention to the leading edges of the paper because feeding errors may
occur unless the paper is properly aligned.
2.
Adjust the side guide in order to close a gap between the paper and the side
guide then fix it with the side guide knob.Note a large gap because mark reading
becomes unstable.When moving the side guide loosen the side guide knob .Then
adjust and tighten the side guide knob and fix.
Note)
When the side guide is pushed to seat side too much, there are times
when it becomes cause of no feed error.
Note)
When using paper other than IBM card size, set the paper-feeding
auxiliary bracket at the bottom end of the paper.
-26-
Side guide
Timing mark
Paper-feeding auxiliary bracket
Side guide knob