OfficeServ 7030
TECHNICAL MANUAL
2.2 Mounting the Boards
This section describes how to set the base board switches and mount the optional boards.
2.2.1 Removing Dummy Parts
Depending on daughter boards, remove the cabinet's dummy parts with pliers.
2.2.2 Setting Switches
The base board is equipped with switches relative to the user requirements, system
configuration and/or daughter boards are as follows:
Board
Switch
Base
S1 (1~8)
Figure 2.6 Removing the dummy parts
Table 2.1 Jumpers/Switches of the Base
Description
Sets the country code and future use (leave at default)
2.4
Home Page
INSTALLATION
PART 2 MAY 2010