2.2 Mounting the Boards
This section describes how to set the base board switches and mount the optional boards.
2.2.1 Removing Blanking Panels
Depending on daughter boards, remove the cabinet's blanking panels with a cutter.
2.2.2 Setting Switches
The base board and the EPM board are both fitted with switches that might need to be set
by the installer depending on user requirements, as follows:
Board
Base
S1 (1~8)
EPM
S1 (1~2)
© SAMSUNG Electronics Co., Ltd.
Figure 2.5 Removing the blanking panels
Table 2.1 Jumpers/Switches of the Base/EPM Board
Switch
Sets the country code
Sets whether to use the 4LM daughter board and whether
to use the Expansion cabinet.
OfficeServ 7030 Installation Manual
Description
2-11