OfficeServ 7030
TECHNICAL MANUAL
6.2.7.2 Attaching iDCS 14 Button AOM to an iDCS Keyset
To add an iDCS 14 Button Key Strip to your iDCS keyset, follow these steps: (see Figure 6.15)
1) Place the keyset face down on a flat surface.
2) Remove the base pedestal by placing your thumbs over the attachment clips and press
outward while simultaneously pressing down on the keyset body with your fingertips.
3) Remove the ribbon cable knockout from the bottom of the keyset.
4) Clip the 14 button strip to the side of the keyset.
5) Plug one end of the ribbon cable into the keyset and the other end into the 14 button
strip.
6) Place the support bracket over the ribbon cable and secure with the six screws provided.
7) Reattach the base pedestal.
Figure 6.15 Attaching iDCS 14 Button AOM to an iDCS Keyset
REMOVE
KNOCKOUTS
6.18
Home Page
INSTALLATION
PART 6 MAY 2010