Installing Interface Boards/Cards - Samsung OfficeServ 7200-S Installation Manual

OfficeServ 7200-S
TECHNICAL MANUAL
3.3 INTERFACE BOARDS/CARDS
This section describes how to set jumpers and switches of an interface board, how to install
optional daughterboards on an interface board, and how to install interface boards into
cabinet slots.

3.3.1 Installing Interface Boards/Cards

Interface boards may be installed in slot 1 through slot 5 of the cabinet with some restrictions.
The following table describes the slot locations for interface board type. The locations of slot
0 through slot 5 of the cabinet are described in
Category
Trunk Cards
Station Cards
VoIP, Wireless
and Data
Modules
The procedure for installing the interface board to each slot is as follows:
1) Check the exterior of the interface board for any damage.
2) Align each interface board to the guardrails of the universal slot of the OfficeServ 7200-S
main cabinet, and slide the interface board into the slot.
Section 3.1 'Cabinet
Table 3.5 Types of Interface Board and Applicable Slots
Interface Board
TEPRI/TEPRIa
8TRK/8TRK2,16TRK
8DLI, 8SLI/8SLI2, 16SLI2,
16DLI2,
8COMBO/8COMBO2,
16MWSLI
PLIM/PLIM2/LIM
OAS
GPLIMT
UNI
Figure 3.11 Installing Interface Board into Slot
3.10
Configuration'.
Applicable Slot
Slot 3 through slot 5 of the cabinet
Slot 1 through slot 5 of the cabinet
Slot 1 through slot 5 of the cabinet
Slot 1 through slot 5 of the cabinet*
Slot 3 through slot 5 of the cabinet
Slot 1 through slot 5 of the cabinet*
One per system.
Slot 1 through slot 5 of the cabinet
Home Page
INSTALLATION
PART 3 MAY 2010