Removing The Infrared Rotisserie Burner Hot Surface Or Spark Igniter & Thermocouple - KitchenAid KFRS271TSS Technical Education

REMOVING THE INFRARED ROTISSERIE BURNER HOT
SURFACE OR SPARK IGNITOR & THERMOCOUPLE
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Turn off and disconnect the gas supply
going to the grill.
Thermocouple
Hot Surface
Ignitor
2. To remove the infrared rotisserie burner
hot surface ignitor (u models only):
a) Remove the control panel (see page
4-2 for the procedures).
b) Disconnect the infrared rotisserie burner
hot surface ignitor wire from igniter
switch terminals.
Hot Surface
Ignitor Wires
Infrared Rotisserie
Burner Gas Valve
c) Remove screw from the rear access
panel and remove the panel.
d) Remove the screws from the infrared
rotisserie burner ignitor & thermocouple
cover and remove the cover.
Hot Surface Ignitor
and Thermocouple
Cover
Screws
(1 of 2)
4-4
Rear Access Panel
Screw