Removing The Infrared Rotisserie Burner - KitchenAid KFRS271TSS Technical Education

Outdoor gas grill
Table of Contents

Advertisement

REMOVING THE INFRARED ROTISSERIE BURNER

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Turn off and disconnect the gas supply
going to the grill.
2.
Remove the infrared burner ignitor from
the grill (see step 2 on page 4-4 for the
procedure).
3.
Remove the screw from the rear access
panel and remove the panel.
Rear Access Panel
4. Disconnect the gas line fitting going to the
infrared burner.
Disconnect Gas
Line Here
5.
Remove two screws holding grill hood to
hood assembly and remove hood.
Screw
6.
Remove twelve screws holding rear panel
to hood assembly.
Rear Panel
Screws
1 of 12
7.
Remove screws holding infrared rotisserie
burner to hood assembly.
Infrared Rotisserie Burner
Rear Of Unit Hood Assembly
7.
Slide infrared rotisserie burner forward out
of hood assembly.
REASSEMBLY NOTE: Turn on the gas to the
grill, and test all of the connections by brushing
on an approved noncorrosive leak-detection
solution. Bubbles will indicate a leak. Correct
any leaks found.
4-7
Rear Of Unit
Screws
Screws
Hood Assembly

Advertisement

Table of Contents
loading

Table of Contents