Buffalo TeraStation TS4800D User Manual page 66

1
Open the front cover with the included key.
2
The failed drive's status LED will be glowing red. Push its unlock button and swing the lock mechanism out.
3
Pull out the drive cartridge and remove it from the TeraStation.
4
Insert the new drive in the empty slot. Slide the drive in with the locking mechanism open. Swing the lock back
down until it clicks into place.
5
When the replacement drive is recognized, the status LED will flash red and the message "Press FuncSW I31 New
Disk x ready" will be displayed on the LCD panel.
6
Hold down the function button on the front of the TeraStation for 3 seconds until it beeps. The replacement hard
drive is automatically registered as a hot spare.
To use the replacement disk as a normal drive rather than a hot spare, navigate to Drives - RAID and click the RAID
array, select the new drive, and click Set as a normal disk.
Replacing a Media Cartridge
Drives configured as media cartridges may be removed and moved to a different TeraStation for use. Before unplugging
the drive, dismount it in Settings or shut down the TeraStation.
66