Buffalo TeraStation TS4800D User Manual page 12

3
Follow the steps on the screen to connect the TeraStation's Ethernet and power cables and turn it on.
Note: Use LAN port 1 for initial setup. After setup, you may connect a second cable to LAN port 2. If you use LAN
port 2, configure the IP address at Network - IP Address in Settings.
4
Follow the steps on the screen to install NAS Navigator2.
5
Click Finish. NAS Navigator2 will open.
6
Right-click on your TeraStation's icon and choose Properties.
Note: For Mac OS, select the TeraStation's icon while holding down the control key, then click Configure.
7
Click the IP Address tab, enter the desired settings, and click OK.
12