Buffalo TeraStation TS4800D User Manual page 146

Media cartridge cannot be decrypted.
Cartridgex I36
The media cartridge may have been
encrypted by a TeraStation other than
Decryption error
this product.
Recovery I37
System recovery in progress.
SystemRecovering
Recovery I38
System recovery is complete.
RecoveryFinished
Recovery I39
System recovery from the USB
recovery device is complete.
Change Boot
Recovery I40
Beginning recovery. All data on the
drive in Disk 1 will be deleted.
DataWillDeleted
Recovery I41
Pressing the Function button on the
front will start the recovery process.
PushFuncToStart
Recovery I42
Preparing to start the recovery
process.
Preparing
The TeraStation was started from the
Recovery I43
USB recovery device, but the system
cannot be recovered from this USB
Unsupported HW
recovery device.
Recovery from the USB recovery
Recovery I44
device was initiated, but Disk 1 was
Disk1 not found
not detected.
Recovery I45
Recovery failed.
Recovery Failed
RAID ARRAY I46
RMM+Processing
Data migration or conversion (RAID
migration) is in progress.
SYSTEM I47
Don't Power Off
This TeraStation is ready to become
FailOver I48
the failover backup for the main
PushFuncToStart
TeraStation.
FailOver I49
The main TeraStation in the failover
configuration cannot be found.
LostMainTarget
FailOver I50
Failover maintenance is in progress.
Maintenance mode
FailOver I51
Initializing the failover configuration.
Initializing
New Firmware I52
A new firmware version has been
released.
Available
BackupTask xx I54
xxth backup task has been failed.
Backup Failure
Connect to the TeraStation that performed
encryption to decrypt.
-
-
Change the boot mode switch on the rear to HDD.
-
-
-
-
Make sure that Disk 1 is present and fully inserted in
its slot.
-
Do not turn off the TeraStation power.
Hold down the Function button on the front of the
target TeraStation until it stops beeping to accept
failover backup status.
Make sure that the main TeraStation is on, working,
and connected to the network.
Do not turn off the TeraStation power.
Do not turn off the TeraStation power.
Update the firmware.
Make sure xxth backup task is configured correctly.
("xx" is backup task number.) The LinkStation or
TeraStation may be in standby mode. Start the NAS
on. If the backup task still fails, check the status of
NAS, network, and backup source or destinations.
146