Programming A Sample System; The Sample System; Setting Up The System; Setting The Keypad Partition And Keypad Number - GE CS5500 Programming Manual

6 P
6.1

The sample system

This chapter explains how to program a basic system using the tasks and settings
outlined in Table 4. More information on installing a basic system can be found in the
Installation Manual. Enter 1122 to silence the keypad if it starts beeping during
programming.
Task

Setting up the system

Setting the keypad partition and keypad number

Setting the system date and time
Enrolling the system modules
Defaulting the panel
Defining the country code
Configuring the system
Configuring the keypads
Configuring zones
Configuring the phone settings
Programming the wireless modules
Defaulting the wireless modules
Programming the wireless detectors
6.2 Setting up the system
When you have installed the system, select the user interface language. For more
information on changing the language, see page 9.
6.2.1 Setting the keypad partition and keypad number
You must set the partition and keypad number for the current keypad. The keypad can
connect to the bus only after you set these numbers.
1.
ROGRAMMING A SAMPLE SYSTEM
The keypad prompts you to enter the partition number for the current keypad.
Programming information
Partition 1
Master user code
Module 0
Partition 1
Keypad 1
Keypad 2
4 hardware zones:
Zone 1 is an entry/exit zone.
Zone 2 and 3 are burglary zones.
Zone 4 is a fire zone.
Phone number: 0852525
Account Code: 112233
Protocol: SIA
RF receiver module 32
2 zones:
Zone 9 is a door/window sensor burglary zone.
Zone 10 is a PIR detector burglary zone.

Table 4 A sample system