Entering The Program Mode; Selecting The Module To Program; Programming A Feature - GE NetworX Series Installation And Setup Manual

1. Entering the Program Mode

Action
[
Go To Program Code
Factory default is

2. Selecting the Module to Program

All modules connected to the NX16 control panel are programmed using the code pad. So the module
you are programming should be the first entry.
#

3. Programming a Feature

Once the number of the module to be programmed has been entered, the LCD screen will prompt you for
a feature number. Any feature can be accessed by directly entering the desired programming feature
followed by the pound/hash [
will display the feature number on the left and the segment number on the right. The bottom line of the
display will show the current data. This data will be displayed and entered according to the type of data
used (numerical, binary, or character data). Follow the instructions below for each type of data.
3a. Numerical Data
The top line of the display will show the current feature number on the left and the segment number on the
right. The data will be displayed on the bottom line. The hex equivalent will be shown in parenthesis. To
change the data in the current feature, enter the number followed by
segment will be incremented by 1. The data for this segment will now be displayed. Continue this process
until the last segment is programmed. When the last segment is reached, the code pad will prompt you for
the next feature. If you wish to exit this feature before the last segment is reached, press #. This key
press will not save the changes made to current segment, but will exit the feature.
Shortcut keys:
4
]
#
] key. If the feature entered is a valid feature, the top line of the LCD screen
Result
Enters the program mode. On Bypass Partial
Exit & Chime LEDs will flash.
Prompts for the programming code.
If the 'Go To Program Code' is valid,
screen will prompt for the device address to program.
You are now in the program mode and ready to
select the module.
Programs the NX16 control panel
is the module number for the control panel and
#
is the enter key. Other module entry numbers
can be found in their corresponding manuals.
. The data will be entered and the
Previous feature.
Same feature.
Next sequential feature.
NX-148E LCD Code Pad Installation and Setup Manual
the LCD