GE CS5500 Programming Manual page 70

Term
Program/Download
Programming
Programming mode
Protocol
Proximity Readers
Pulsed Keyswitch
Q
Quick Arm
R
Ready light
Ready State
Receiver Features
Receiver modules
Recent Closing
Recording
Re-exit
Reject beep
Relay Active Time
Relay State
Report Codes
Report Mains Fault
Always
Definition
A menu option that reports programming and up/download events to the selected
phone number. (Phone Number)
A menu option that reports programming and up/download events to the central
station depending on the condition of the panel dialler. (CS7001 GSM Module)
See also Panel Dialler OK Events and Panel Dialler Not OK Events
A menu entry that groups home automation commands.
A mode of operation in which the installer can program the control panel after
entering the Installer code to access the installer menu.
A menu option that sets the communicator format used to transmit to the receiver
connected to a phone. Up to six phones can be set up. Multiple formats are
available, such as Contact ID, SIA, 4+2 and pager format. Contact ID and SIA are
the recommended formats. See appendix 4 for more information on communicator
formats. (Phone Numbers)
A menu option that sets the home automation protocol to binary or ASCII. (Home
Automation)
See CS1700 Proximity Readers
A zone characteristic that allows a zone input to be used with a momentary
keyswitch. Each activation of the keyswitch toggles the armed state of the control.
A menu option that enables the function keys for part arming and for full arming.
These options work on a single-area keypad only.
An LED light indicating that the system is ready to be armed. The light is on when
the system is ready to arm and off when it is not ready due to faulted zones. The
light flashes when the system is ready to force arm.
A menu option that lights LED 1 (Green) when the system is ready to be armed.
A menu entry that groups programmable options for RF receivers.
Modules that add wireless capability to the control panel. Adding a receiver
module makes the control panel compatible with wireless transmitters or keyfobs.
A menu option that sends a report to the central station if an alarm occurs within
five minutes after the panel has been armed. The user number that armed the
system is also sent. (Communications)
A menu entry that specifies the code (SIA/ContactID/FastFormat/200Bd FSK) or
voice channel to be used for recent closings events. (Report Codes)
A menu entry that groups recording options for messages sent by the CS535
voice module.
A menu option that enables the exit delay without disarming the system.
The exit delay can be restarted if in arm stay mode by using the Arm Away
command in the user menu or by pressing a function key programmed by the
installer to activate arm away.
An audio signal generated by the keypad buzzer that indicates code, command or
value update rejection.
A menu option that sets the length of time the relay is activated when a proximity
card is held against the CS1700 proximity reader.
A menu option that lights the selected LED when the device's relay is activated.
A menu option that groups codes that are sent to the central station when a
particular event occurs.
A menu option that sends a report to the central station if power is lost for the time
programmed in Mains Delay Time. If this option is disabled, the report is sent only
if the control panel has not sent a mains power lost report and Mains Fail report is
enabled.
This option applies only to the CS320 power module and not to the control panel.