Keypad Functions; Arming Your System In The "Away" Mode - GE LCD Keypad User Manual

Police (Panic/Hold-Up) Key - If programmed, when the Emergency Activation
[Police] key is pressed for two seconds, a local audible alarm will sound. If your
system is connected to a monitoring center, an emergency report could be
transmitted to that center. These keys should only be pressed in an emergency
situation requiring immediate response by law enforcement personnel. NOTE:
Some Panic/Hold-Up alarms are programmed to be silent at the protected site
while reporting an alarm to the monitoring center. Check with your installing
company to determine how your security system will respond to the Panic/Hold-Up
activation.
No one at premises; total interior and exterior protection.
Building is occupied; protection around the perimeter.
Building is occupied; protection around the perimeter and selected zones
(doors, windows, sensors).

ARMING YOUR SYSTEM IN THE "AWAY" MODE

1. Close all protected doors and windows.
The System Ready message will be displayed when all protected zones
and sensors are secure. NOTE: If
any zones are bypassed, a
sensor in that zone can be
violated without affecting the
ready status.
The security system will not arm if
the System Not Ready message is
displayed. It can be force armed if
the entire System Not Ready
message is flashing. Refer to the
section, "Making Your System
Ready to Arm".
If the "Service Required" message is alternately displayed, you may not
have AC power. Restore power if possible. If not, contact the installing
company.
2. Enter your 4 or 6 digit user code to arm the system.
LCD Keypad

KEYPAD FUNCTIONS

System Ready
Type Code to Arm
System Not Ready
For help, press º
5