Entering The Program Mode; Selecting The Module To Program; Programming A Location; Numerical Data - GE NX-148E Installation And Setup

1. ENTERING THE PROGRAM MODE

ACTION
[
Go To Program
Factory Default is

2. SELECTING THE MODULE TO PROGRAM

Tip: All modules connected to the NX control panel are programmed through the keypad. So the module
you are programming should be the first entry.
#

3. PROGRAMMING A LOCATION

Once the number of the module to be programmed has been entered, the LCD screen will prompt you for
a location number. Any location can be accessed by directly entering the desired programming location
followed by the pound [#] key. If the location entered is a valid location, the top line of the LCD screen will
display the location number on the left and the segment number on the right. The bottom line of the
display will show the current data. This data will be displayed and entered according to the type of data
used (numerical, binary, or character data). Follow the instructions below for each type of data.
3a. NUMERICAL DATA
The top line of the display will show the current location number on the left and the segment number on
the right. The data will be displayed on the bottom line. The hex equivalent will be shown in parenthesis.
To change the data in the current location, enter the number followed by
the segment will be incremented by 1. The data for this segment will now be displayed. Continue this
process until the last segment is programmed. When the last segment is reached, the keypad will prompt
you for the next location. If you wish to exit this location before the last segment is reached, press #. This
keypress will not save the changes made to current segment, but will exit the location.
Shortcut keys:
4
]
Code
Enters the Program Mode.
Prompts for the programming code.
If the "Go To Program Code" is valid,
screen will prompt for the device address to program.
You are now in the Program Mode and ready to
select the module.
Programs the NX Control Panel
is the module number of the control and # is
the entry key. Other module entry numbers can
be found in their corresponding manuals.
. The data will be entered and
Previous location.
Same location.
Next sequential location.
RESULT
LCD KEYPAD
the LCD