GE CS5500 Programming Manual page 61

Term
Interface Configuration A menu option that enables interface configuration transition broadcasts. These
Interior
Internal Reed
Internal Siren
Internal Siren Timeout
Internal sounder
Interval
Inverted
J
Jam Detection
K
Key click
Keychain touchpads
Keyfob
Keyfob Funct 1
Keyfob Funct 2
Keyfob Low Battery
Reports
Keyfob User ID
Definition
broadcasts transmit changes to zones, partitions and so on to the home
automation system. (Transition Broadcasts)
A menu option that enables the control panel to respond to interface configuration
requests sent by the home automation system. (Commands/Requests)
A zone type within the building that is bypassed when the system is armed in stay
mode.
A menu option on an RF door/window sensor that enables the internal reed
contact.
A menu entry that groups options that set the conditions/events that activate the
internal siren. This is a siren which sounds within the building.
A menu option that sets the length of time the internal siren rings before
automatically cutting out. This time can be between 0 and 255 minutes. When set
to 0, the siren is active until a valid code is entered on the keypad.
See Internal Siren
A menu option that sets the length of time between autotests. The unit is set in
autotest control. The Hour and Minute options set the time at which the test is
performed.
A menu option that enables a mode that inverts the state of an output (normally
activated and then deactivated when an event occurs).
A menu option that lights the selected LED (Green/Red) when the device is in
inverted mode. (CS1700 Proximity Reader)
A menu option that enables the detection of RF jamming. The RF wireless
communication is considered to be jammed when there has been a jamming
signal for more than 30 seconds in a 60 second window.
The default sound for any key press.
See Keyfob
A menu entry that groups options relating to any device that sends commands by
a wireless receiver.
A menu option that enables the light bulb button on the keyfob for the selected RF
zone on the selected RF receiver. If this option is enabled, pressing the light bulb
button sends a keyfob function 1 event. Control panel auxiliary outputs and CS507
outputs can be programmed to respond to this event. (RF Receivers)
A menu option that sends a keyfob function 1 event for the selected proximity
reader action. The actions are Single Badge, Double Badge and Badge Hold.
(CS1700 Proximity Readers)
A menu option that enables the * button on the keyfob for the selected RF zone on
the selected RF receiver. If this option is enabled, pressing the * button sends a
keyfob function 2 event. Control panel auxiliary outputs and CS507 outputs can be
programmed to respond to this event. (RF Receivers)
A menu option that sends a keyfob function 2 event for the selected proximity
reader action. The actions are Single Badge, Double Badge and Badge Hold.
(CS1700 Proximity Readers)
A menu option that reports a keyfob low battery condition. This option is available
on the 868 Mhz RF Receiver only.
The low battery condition is reset by pressing the Arm (Lock) and Disarm (Unlock)
button at the same time. If this option is enabled, each enrolled keyfob uses up
one zone in the system. If this option is disabled, keyfobs do not use up a zone in
the system and can overlap with a used zone.
A menu option that makes the keyfob report as the zone that it is learned into.
When this option is disabled, all keyfobs report their open/closing reports as user
99.