Ask Proxima E3000 series User Manual page 83

Blending Debugging Setting
Here take two projectors as example to introduce the blending method.
8.1 Connect these two projectors by the aforesaid networking method. After successful
connection, an interface as shown below appears. Mark the left projector as "1" and the right
projector as "2" in "Remark name" column, as shown below. If you are not sure which one is
the left one and which one is the right one, double click "27" or "7847" in "ID" column to enter
control interface. Press any key in that interface, and the projector will give corresponding
reply. Doing so, you will be clear about which projector is the left one and which projector is
the right one.
8. 2 Double click "27" in "ID" column, a image appears as shown below. Select "Blending" ->
"Pattern HxV". Select "2X1" -> Set "Local Position" to "1" ->Check "Welding line" ->Click "Save
and refresh PW data" as shown below.
8.3 Set the other projector in the same way as described in step 2. Double click "7847" in "ID"
column, a image appears as shown below. Select "Blending" -> "Pattern HxV". Select "2X1"
-> Set "Local Position" to "2" ->Check "Welding line" ->Click "Save and refresh PW data" as
shown below.
ZIGBEE Networking Instructions
83