Ask Proxima E3000 series User Manual page 48

Advanced setting
Enter a PIN code
Press  buttons to enter a number. Press  button to fix the number and move the red
frame pointer to the next box. The number changes to "*". If you fixed an incorrect number, press
 button to move the pointer to the number you want to correct, and then press  enter the
correct number.
Repeat this step to complete entering a three-digit number.
After entering the three-digit number, move the pointer to "Set". Press the SELECT button so that
you can start to operate the projector.
If you entered an incorrect PIN code, PIN code and the number (***) will turn red for a moment.
Enter the correct PIN code all over again.
Change the PIN code lock setting
Press  buttons to select Yes or No,and then press the SELECT button to make a choice.
PIN code change
The PIN code can be changed to your desired three-digit number. Press SELECT button to select
PIN code change. Pin code dialog box appears, Press  buttons to enter the correct code. The
New PIN code input dialog box appears. Set a new PIN code.
CAUTION:
WHEN YOU HAVE CHANGED THE PIN CODE, WRITE DOWN THE NEW PIN CODE IN
COLUMN OF THE PIN CODE NO. MEMO ON PAGE 65, AND KEEP IT SECURELY. IF YOU
FORGET YOUR PIN CODE, THE PROJECTOR CAN NO LONGER BE STARTED.
Lamp setting
Two projectlamps are embeded in the projector. This function is used to set the lamp mode, adjust
the lamp brightness and view lamp used time.
Dual...............Two lamps are on at the same time.
Single.............Only one lamp lights on at the same time.
Alternate ........Two project lamps light on alternatively, alternative interval is two hours.
Lamp control: used to adjust the lamp brightness.
Normal...........Normal brightness.
Eco.........Lower brightness, reducing power consumption and extending the lamp life.
Lamp 1 counter....Display the lamp 1 used time.
Lamp 1 status.....Display the status of lamp 1.
Lamp 2 counter....Display the lamp 2 used time.
Lamp 2 status.....Display the status of lamp 2.
Filter counter
This function is used to set a frequency for the filter cleaning.
When the projector reached a specified time between cleanings, a Filter warning icon appears on
the screen, notifying the cleaning is necessary. After cleaning the filter, be sure to select RESET
and set the timer. The Filter warning icon will not turn off until the filter counter is reset.
Filter counter.............The time that filter used.
Timer.........................Frequency for filter cleaning.
Filter counter reset....Reset the filter counter.
Warning log
Recording abnormal operations, facilitating to diagnosing errors. The log lists the latest 9 warning
messages in time sequence.(The lastest warning message is arranged at the top of the warning
log list.)
Note:
When Factory Default is selected, all log records will be deleted.
48