Filter Settings - Sony SNT-EX101 User Manual

Enable/Disable checkbox for filter
Set enable/disable for individual inspection methods.
Filter order switching button
Clicking switches the order of inspection methods
between the neighouring methods.
e.g., If you click the button between 1 and 2, they will
switch order. If you click the button between 2 and 3,
they will switch order.
Specifying the time for "When all occurs in
order"
Specify the reference interval in seconds between 1 and
2, or 2 and 3.
For example, if "At least 3 seconds" is specified, the
state of 2 being acknowledged two seconds after 1 has
been acknowledged will not validate the
acknowledgment of 2.
VMF status indicator
The indicator is on when the set filter type conditions are
met.

Filter settings

Settings for each filter can be edited here.
The inspection line and active window are set to default
values. Edit according to use.
VMF status indicator of each filter
The filter is on when the set filter type conditions
(Passing, Existing, Appearance, Disappearance,
Capacity) are met.
Tip
The buttons displayed on the edit screen for inspection
method is used in the same way as those for detection
setting. See page 84.
86
Setting the Sensor input/Camera tampering detection/Motion detection/Audio detection — Event detection menu
Passing
Edit the pass inspection line according to the following
procedure:
Passing object trigger line
By default, one passing object trigger line is displayed.
The number of vertexes is 2.
Placing the cursor on the line will turn the cursor into a
cross, and when you drag the line, the whole line will
move.
Placing the cursor on the vertex will turn the cursor into
n, and when you drag the line, the vertex will move.
The arrow displayed in the center of the passing object
trigger line shows the direction of inspection. trigger is
performed when an object passes the passing object
trigger position in this direction.
Trigger direction setting
Each time you click , the trigger direction toggles
among the directions left, right and both.
Passing object trigger position
Select the passing object trigger position from Center,
Left side, Top side, Right side and Bottom side.