Alarm Sending Tab - Setting The E-Mail Sending Mode When Detecting The Alarm - Sony SNT-EX101 User Manual

Alarm sending Tab — Setting the
e-mail sending mode when
detecting the alarm
Set to send an e-mail linked with alarm detection by the
external sensor input or by the built-in detection
functions.
Alarm sending
Select On to set sending an e-mail linked with alarm
detection.
File attachment
Set whether an image file (JPEG file) is to be attached to
the e-mail or not.
When On is selected, the image file made using the
settings below is attached. When Off is selected, only
the message is sent.
Image file name
Type the file name you want to assign to the image to be
attached to an e-mail. You can use up to 10
alphanumeric characters, - (hyphen) and _ (underscore)
for naming.
Suffix
Select a suffix to be added to the file name.
None: No suffix is added. The image file name is
assigned to the image to be sent via e-mail.
Date & time: The date & time suffix is added to the
image file name.
The date/time suffix consists of lower two-digits of
the year (2 digits), month (2 digits), date (2 digits),
hour (2 digits), minute (2 digits), second (2 digits),
and sequential number (2 digits), thus adding 14-
digit number to the image file name.
Sequence number: A sequential number of 10 digits
between 0000000001 and 4294967295 and two fixed
digits 00 are added to the image file name.
Sequence number clear
Click Clear to reset the Sequence number suffix to 1.
Alarm
Select the alarm to be linked with e-mail notification.
Tip
The number of selectable input terminals is as follows:
SNT-EX101/SNT-EX101E: 2
SNT-EX104/SNT-EX154: 4
SNT-EP104/SNT-EP154: None *
* Alarm sending is available only for the simple motion
detection function.
Sensor input 1: The external sensor that is connected to
sensor input1 of the I/O port.
Sensor input 2: The external sensor that is connected to
sensor input 2 of the I/O port.
Sensor input 3: The external sensor that is connected to
sensor input 3 of the I/O port.
Sensor input 4: The external sensor that is connected to
sensor input 4 of the I/O port.
Tampering: An alarm that is triggered when the camera
detects tampering, such as direction shift or spraying.
Interval: Set the interval at which you want to send an
e-mail periodically after detection.
E-mails are sent after a specified interval time until
the Camera tampering detection setting is cleared or
the detection setting is turned off. You can set the
hour (H) and minutes (M) between 30 minutes and
24 hours (one day).
When file attachment is set to ON, a file is only
attached to an initial mail and will not be attached to
the following mails.
VMF: An alarm of the VMF detection function.
Motion detection: The alarm detected by the motion
detection function.
Click Detection, and the motion detection menu is
displayed to allow you to set the motion detection
function (page 81).
Audio detection: Select the preset position linked with
alarm by audio detection function.
Click Detection, and the audio detection menu is
displayed to allow you to set the audio detection
function (page 81)
Note
In the case that the synchronized preset position is
specified in Position at alarm in the Preset position
menu, an alarm event that happens when the camera
moves to the preset position will be invalid.
Sending an Image via E-mail — e-Mail (SMTP) Menu
63