Otto Bock A 200 Instructions For Use Manual page 7

5. Release the seat lock by simultaneously pulling the release strap and folding the locking bar to the rear
(Fig. 2).
6. Remove the battery packs by releasing the Lock Lever (Fig. 6).
7. Separate the frame from the drive unit assembly.
Place your weight on the mounting of the anti-tipper above the wheels so the wheels touch the ground
(Fig. 3). Next, separate the frame from the drive unit assembly by slightly lifting the frame and pulling it to
the rear (Fig. 4).
8. Fold the seat base onto the frame.
To do this loosen the two quick release levers of the anterior seat brackets and fold the seat base down
whilst simultaneously lifting the brackets slightly and pushing them to the rear (Fig. 5).
Figure 3
Figure 5
To reduce the space needed, the two battery packs can be replaced into the drive unit assembly. To prevent
the battery packs from falling out of the drive unit assembly, the locking lever must be relocated (Fig. 6).
The control panel can either be laid onto the battery packs or put into the holder provided for this purpose.
Ensure the control panel remains switched off and that no cables are pinched (Fig. 6).
Figure 6
For re-assembly of the A200 power wheelchair the steps described above must be carried out in reverse order.
Figure 4
Figure 7
25