Troubleshooting - ALDI 49291 User Manual

Understanding and using these operating instructions

Troubleshooting

Problem
Engine does not start Fuel tank (25) is empty
Cutting / Engine
performance
decreases
60L hard catcher
is not filling up to
optimum level
Mower cannot be
pulled backward
Self propel does not
operate
For issues relating specifically to the Briggs and Stratton engine, please contact
Briggs and Stratton via www.briggsandstratton.com or calling Customer Service
on (03) 9796 4900. For all other issues, please contact Customer Service on 1800 909 909
or email help@powertoolsupport.com
34
e-mail: help@powertoolsupport.com
MODEL: №. 49291 • 08/2015 • 49291
Possible Cause
Oil tank is empty
Motor throttle control (5)
is not in correct starting position
Spark plug (27)
Blades hitting the grass to be cut
Cutting height
4 x swing blades (30) are dull or blunt
When using side discharge chute (20)
60L hard catcher (14) is full
Cutting height too low
When Mulching, piles of grass are left
behind the mower
Grass is wet
4 x swing blades (30) are dull or blunt
Rear discharge chute (16) is blocked
Gearbox is engaged
Gear box not engaged
Motor not operating
190cc 4 Stroke Petrol Lawn Mower
Solution
Check the fuel tank (25), and refuel if
required.
Check the level of the oil dipstick (24),
and if low or empty, add oil
Move the motor throttle control (5)
to the correct "START" position
Clean or replace if dirty or worn
Increase the cutting height of the mower
so the blades do not make contact with
the grass on start up
Increase the cutting height using the
8 height adjustment lever (18)
Replace the blades with new / sharp
blades.
Clean around the side ejector chute (20)
NOTE: Always ensure the engine is turned
off before undertaking this task.
Empty 60L hard catcher (14)
Increase the cutting height using the
8 height adjustment lever (18)
Lift the height of the cutting depth by one
notch using the 8 height adjustment lever (18)
Allow the grass to dry before mowing
Sharpen or replace the 4 x swing blades (30)
Stop mower and clear the rear discharge
chute (16)
Release the self propelled engage/
disengage bar (2)
Fully lift self propelled engage/disengage
bar(2) against the top handle bar (1)
Start motor and retry
AFTER SALES SUPPORT
1800 909 909
(toll free)