Removing Oil - ALDI 49291 User Manual

190cc 4 Stroke Petrol Lawn Mower
6. Replace all 4 blades to ensure a smooth even cut and re-fit them on the
mower in the reverse direction they were removed. (Fig AK)
7. Lastly, secure the nuts firmly, (20-25Nm) repeating this for the other
3 blades.
8. Replace the blade mounting plate (37) with new blades attached, then
the outer flange (32), followed by the blade bolt (31). Retighten the blade
bolt tightly (50 – 59Nm).
NOTE: Use a wooden block to stop the blade from turning. The 4 blades
should be tightened fully but check to ensure they can still swing back
if they were to hit a solid object. Where required tighten the bolts with a
torque wrench, the centre disc blade bolt torque: 50 – 59Nm and the four
blades torque: 20-25Nm. If you do not have a torque wrench ask a mower
service dealer to tighten the blade bolts before you use the mower.
Blades should be replaced when they become worn and no longer cut
the grass cleanly. The performance of grass catching can also reduce if the
blades become worn. Replacement blade sets are available for purchase
from www.extrabattery.com.au, or by calling 1800 909 909.

Removing Oil

IMPORTANT: Drain the oil while the engine in still warm to ensure rapid and
complete draining.
1. With the engine off but still warm, disconnect the spark plug cover and
make sure it is kept away from the spark plug (27).
2. Remove the blade bolt (31) using a 17mm spanner (not supplied) by
turning in an anti-clockwise direction (Fig AG), then remove the outer
flange (32) (Fig AH). This allows you to be able to remove the blade
mounting plate (37) from the lawn mower.
3. This engine is equipped with a bottom
oil drain plug (36) (Fig AL) Remove the
oil drain plug using a 3/8" square adaptor.
(Fig AM)
WARNING:
Oil may be hot.
AFTER SALES SUPPORT
1800 909 909
(toll free)
Operating instructions and safety notes!
AM.
e-mail: help@powertoolsupport.com
MODEL: №. 49291 • 08/2015 • 49291
AL .
27