Starting The Engine - ALDI 49291 User Manual

190cc 4 Stroke Petrol Lawn Mower

Starting the engine

NOTE: Before starting the mower check the oil and fuel levels. The motor
MUST be filled with 600ml of SAE 10W/30 BEFORE starting. Fresh unleaded
fuel must be used in this unit. Do NOT use Ethanol based fuels. Do NOT mix
oil with fuel.
Warranty will be void if the engine becomes faulty due to insufficient oil and
fuel levels.
For starting, ensure the mower is set to the height setting so the blades are
not resting deep into the grass.
NOTE: The engine of this lawn mower is a Briggs and Stratton, Readystart®,
Model 675E. It features a temperature controlled automatic choke. It does
not have a manual choke or a primer.
NOTE: When starting the engine, and using the motor throttle control (5)
when standing behind the mower, motor throttle control (5) is on the right
hand side.
W.
1. Move the motor throttle
control (5) to the "START "
position. (Fig W)
2. Firmly hold the recoil starter
(23) & pull slowly until
resistance is felt, then pull
rapidly. (Fig X)
3. Once the lawn mower has
started and warmed up
(approximately 20-30 seconds)
move the throttle control (5) to
the "RUN" position to increase
the engine speed. (Fig Y)
AFTER SALES SUPPORT
1800 909 909
(toll free)
Operating instructions and safety notes!
X.
The engine can be
started anywhere
in this position
when the engine
is warm / hot.
Y.
RUN
Move the motor
throttle control
(5) to the rabbit
position for all full
power mowing
Always have the
START
motor throttle
control (5) in this
position when
starting a cold
engine.
OFF
e-mail: help@powertoolsupport.com
MODEL: №. 49291 • 08/2015 • 49291
21