Assembly; Attaching The Lower Handles - ALDI 49291 User Manual

Understanding and using these operating instructions

Assembly

WARNING: Stop the engine and unplug the spark plug before any
repairs or maintenance operations.
WARNING: DO NOT attempt to start this mower without first adding
0.6L of SAE 10W/30 engine oil to the Engine. Refer to the oil chart on
page 16 to confirm the correct oil for various conditions.
WARNING: Do Not attempt to start this mower without the mower
first being FULLY assembled.
It is necessary to fit the lower handles (9), upper handle and bar (1),
and the 60L hard catcher (14) to the mower before use.

Attaching the Lower Handles

NOTE: When preparing for this assembly, slowly and carefully raise the
handles without pulling or putting any strain on the cables. Ensure cables
are not tangled or crossing over.
1. Remove the lower handle locking knobs (11) from the lower handle
mounting plates (12). (Fig A)
2. Position each of the lower handles (9) on the inside of the lower handle
mounting plate (12), and locate the circle hole on each end of the lower
handles (9) onto the large locating pins (one each side) on the lower
handle mounting plates (12) on each side. (Fig B)
3. This mower has a 3 height adjustment for the positioning of the handles,
with the lowest notch positioning the handle bars closer to the ground,
and the highest notch raising the handle bars up towards the user. (Fig C)
A.
14
e-mail: help@powertoolsupport.com
MODEL: №. 49291 • 08/2015 • 49291
B.
190cc 4 Stroke Petrol Lawn Mower
C.
AFTER SALES SUPPORT
1800 909 909
(toll free)