Scope of delivery/device components Scope of delivery/device components Handle grip (top) Pull relief (for the power cable) Quick-release lever (handle joint) Bottom part of handle Collecting bag Connecting piece (2x) Carry handle Cutting height lever Motor unit Connection cable Handle mount Quick-release lever (handle mount) Discharge flap Fill level indicator...
Table of content Table of content Overview........................2 Scope of delivery/device components..............4 General information....................6 Reading and storing the operating manual..............6 Proper use...........................6 Explanation of symbols...................6 Safety........................8 Before first use......................11 Check the device and scope of delivery.................11 Mounting the handle......................11 Preparing the collecting bag..................12 Operation.......................
General information General information Reading and storing the operating manual This operating manual is part of the electric lawn mower (hereinafter also called "device"). It contains important information on how to set up and use the product. Before using the device, read the operating manual carefully, in particular the safety instructions.
Page 7
Explanation of symbols General warning sign. Caution! Discharge of cuttings or stones. Always keep the discharge flap closed. Warning! Rotating blade! Do not reach or step underneath the device. Warning! Electric voltage. Read the operating manual. Keep other persons and animals out of the working range! Disconnect the device from the mains before carrying out maintenance and cleaning work.
Explanation of symbols Cutting width of the device. The symbol shows the maximum sound power level L IPX4 The device is protected from all sides against water splashes. Safety The following signal words are used in this operating manual. This signal symbol/word denotes a WARNING! hazard with an average risk level that could lead to death or severe injury if...
Page 9
Safety - In the case of a fault, immediately disconnect the device from the power cable and/or mains. - Do not connect the device if the device, power cable or a mains plug shows visible signs of damage. - Damaged power cords and devices must only be repaired by the manufacturer, their customer service or a qualified professional.
Page 10
Safety older persons with reduced physical and mental capacities) or lack of experience and knowledge. Improper handling of the device can lead to severe injuries or damage to the device. - This lawn mower may be used by persons with impaired physical, sensory or mental capacities or those lacking experience and knowledge if they are supervised or have been instructed in how to safely use the lawn mower and...
Safety - Do not work on areas with an inclination above 20 % as you might slip and lose control of the device. - Always keep the discharge flap closed and keep away from the discharge chute when working without a collecting bag. - Wait until the blade stands still before removing any blockage or clogging and carrying out any other work on the device.
Before first use 3. Place the bottom part of the handle on the handle mount . Check whether the serrations of the locking washer engage correctly in the handle mount. The holes of the handle mount, the connecting pieces and the bottom part of the handle must point towards each other.
Before first use 2. Check whether the plastic rims are properly in place on all sides. Operation Rules of operation The following rules must be observed at all times when working on and with the lawn mower. Do not adjust the device or rectify faults when it stands still. Make sure that the device cannot start up.
Operation Undo the two quick-release levers on the handle mount. 2. Set the handle to the desired height. 3. Check whether the serrations of the locking washer engage correctly in the handle mount 4. Flick the quick-release levers Adjusting the cutting height You can set the cutting height between approximately 20 and 70 mm.
Operation Emptying the collecting bag The collecting bag has a fill level indicator . The fill level indicator rises when the motor is running and the collecting bag is empty. Once the collecting bag is full, the fill level indicator rests again on the collecting bag. Empty the collecting bag. If cuttings remain on the ground, empty the collecting bag as well.
Cleaning NOTE! Improper cleaning can damage the device. - Do not use any harsh cleaning products, brushes with metal or nylon bristles, or sharp or metallic cleaning materials such as knives, hard scrapers or similar. They may damage the surfaces. - Remove wet cuttings immediately.
Maintenance In addition, check the following once a year: Free wheel movement. Function and free movement of the cutting height adjuster Function and free movement of the discharge flap Damage to the device, such as broken housing parts or worn collecting bag If you detect any defects, contact customer service or a specialist workshop.
Storage Storage conditions Thoroughly clean the device (see “Cleaning”). Store the device in a clean, dry, frost-protected place out of the reach of children. Store the device in a location away from sunlight and other heat sources. Always store device parts and accessories together with the device. Store the device and accessories at a temperature between +5 °C and +20 °C.
Troubleshooting Problem Possible cause Fault rectification Unsteady run The selected cutting height is Set the cutting height 2 levels too low. higher. The device emits unusual noises Insufficient power Collecting bag is full to the Empty the collecting bag and rim or the discharge chute is remove cuttings from the clogged.
Page 20
Technical data Mowing length setting: 20–70 mm Guaranteed sound power level L 96 dB(A) Sound power level L 93.5 dB(A) Uncertainty K 0.9 dB(A) Sound pressure level L 85.2 dB(A) Uncertainty K 3 dB(A) Vibration emission value: 2.89 m/s² (K = 1.5 m/s²) Blade type: SMV 1253482000 Item number...
Declaration of conformity Declaration of conformity Original EU Declaration of Conformity MEROTEC GmbH Otto-Brenner-Str. 8, 47877 Willich, Germany herewith declare under our own, sole responsibility that our product Electric lawnmower Model no. GLM44 complies with the following directives: 2006/42/EC Machinery Directive 2014/30/EU EMC-Directive 2000/14/EC Outdoor Noise Directive, amended by 2005/88/EC...
Disposal Disposal Disposing of packaging Dispose of packaging according to type. Sort the paperboard and cardboard as waste paper and the film as recyclable material. Dispose of old electrical device Old electrical devices may not be disposed of as household waste! If the product cannot be used anymore, each consumer is obligated by law to dispose of old devices separately from household waste, e.g.