Troubleshooting - ALDI FERREX GLM44A User Manual

Troubleshooting

Problem
Motor does not start up
Unsteady run
The device emits unusual
noises
Insufficient power
Cuttings left on ground
If the problem persists, contact the customer service listed on the last page.
Possible cause
The mains plug is not
correctly plugged in.
The socket does not supply
any power/the fuse has
blown or the RCCB has
tripped.
The button on the safety
switch was not pushed.
The motor overload
protection has triggered, the
motor is overheated.
The selected cutting height is
too low.
Collecting bag is full to the
rim or the discharge chute is
clogged.
Blade is blocked by foreign
object.
Blade is dull or damaged.
Collecting bag is full to the
rim or the discharge chute is
clogged.
Grass is too wet.
Troubleshooting
Fault rectification
Check that the mains plug is
fitted properly.
Check the power cable for
damage.
Let go of the safety bar and
push the button on the
safety switch before pulling
the safety bar again.
Allow the device to cool
down for 15-20 minutes.
Set the cutting height 2 levels
higher.
Empty the collecting bag and
remove cuttings from the
discharge chute.
Check the blade
compartment for foreign
objects and remove these if
present.
Check the blade and have it
sharpened or replaced at a
specialist workshop, if
necessary.
Empty the collecting bag and
remove cuttings from the
discharge chute.
Wait for the grass to dry.
19