Air Duct Removal; Kozy Heat #816-Cl Co-Linear Vent System - kozy heat Jordan Jor-30 Installation And Operation Manual

AIR DUCT REMOVAL

1. Remove refractory panels (secured at top with clips - 1 ea. side).
2. Remove (3) screws securing baffle to firebox back wall. Pull baffle forward and down to remove.
3. Remove access plate (secured with (2) screws) from firebox ceiling.
4. Locate and remove nuts securing air duct top to firebox; 2 nuts reached through access holes, 2 inside air duct.
5. Remove air duct top.
Access Plate
Figure 15a

KOZY HEAT #816-CL CO-LINEAR VENT SYSTEM

The co-linear pipes included in this vent system are designed to extend up to 35ft. (10.67m)
IDENTIFICATION: Exhaust Pipe: red marking.
IMPORTANT Proper operation of this insert requires exhaust and combustion air pipes be connected to correct collars on termination kit and
insert air duct.
A. Carefully extend exhaust and combustion air intake pipes to equal total chimney length required.
If using stub method for combustion air pipe, extending it is not necessary. Determine length needed from air duct on insert
NOTE (4ft. (1.22m) minimum) to above damper opening in existing chimney. Remove excess combustion air pipe from end without a
collar. Continue with Step B. below.
If using Full Connection method: Slide intake pipe (end without collar ) over collar on ter mination cap. Secur e with 3 self-tapping
B. Place bead of sealant around inner edge at end of exhaust pipe (without collar / red marking) and slide onto corresponding collar on
termination cap (collar with label). Secure with 3 self-tapping screws (provided). Apply additional sealant around joint to ensure a
proper seal.
EXHAUST COLLAR ON FIREPLACE AIR DUCT IS ON RIGHT SIDE. INSTALL TERMINATION CAP WITH EXHAUST COLLAR ON
IMPORTANT
RIGHT SIDE.
T
ERMINATION CAP
INTAKE COLLAR
NOTE: Collar extends through bottom plate.
Figure 15b
INSTALLATION
screws (provided).
15
EXHAUST COLLAR
NOTE: Collar extends through middle divider plate
Your vent cap may look slightly different than one shown.