kozy heat Jordan Jor-30 Installation And Operation Manual page 21

#JOR-500 LOG SET INSTALLATION
NOTE Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
CAUTION
soot to build up on logs and glass.
Figure 18a
Align holes in bottom of base logs J1,J2, & J3 to mounting pins on burner. Push logs down onto pins to seat.
Figure 18b
Install J9 & J10 logs, aligning with notches in lower logs as shown below.
Figure 18c
Randomly place Klinkers in this area. Do not place Klinkers directly on burner ports.
Use a steel or stiff bristle nylon brush to distribute Rock Wool Embers onto logs and burner.
J1
J2
Position J4 log over channel as shown.
J5
J6
Install J5 - J8 logs, aligning with notches in base logs.
J9
18
J3
J4
J7
J10
J8