Answering Mode - TIPTEL 308 clip Operating Instructions Manual

Answering mode

Take care that enough recording capacity for incoming messages is available.
If required, you should erase individual or all recorded messages.
Select the desired OGM by pressing
the lower selection button.
Press the answering mode button.
Use the arrow buttons (left/right) to
adjust the volume.
Press the answering mode button
again to deactivate the answering
mode.
If the recording capacity is exhausted, your tiptel 308 clip automatically switches
to OGM 2, provided that OGM 2 is an OGM without incoming recording
(announcement only). Otherwise, the device will switch the answering mode off
and no further incoming calls will be answered.
Answering mode
The selected OGM is shown at the
bottom right side of the display.
The LED is lit. If you selected an OGM
"without incoming recording", two lines
are shown instead of the number of
messages.
The number of calls shown in the display
blinks when the tiptel 308 clip picks up
an incoming call.
If the caller's telephone number is being
transfered during a call, the display will
show this telephone number instead.
Call screening is possible for incoming
messages. If you decide to answer the
call personally, you can do so at any
time, by just picking up the handset. If
new incoming messages exist, the LED
will blink.
Further incoming calls will not be
answered. The display resumes the initial
state. The LED blinks as long as the
recorded messages have not been
played back.
16