Table of Contents
Advertisement
Available languages
Available languages
GB
SLO
PL
JP
5.4 Setting the total kilometres
You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).
Using
go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode).
Using
go to ODOMETER/
SET. Confirm with
M
.
5.5 Switch from bike 1 to bike 2
Your VDO computer can be used on two bikes.
If you switch from bike 1 to bike 2, you must set the
computer to the bike being used before the ride.
Using
go to SETTINGS/
SELECT. Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode).
14
X1
ODOMETER/ODO BIKE 1
(use
to go to setting for
BIKE 2). Confirm with
M
.
ODO BIKE 1 ...SET DISTANCE/
CONTINUE.
You can set the flashing digits
using
.
To access the next digit, con-
firm with
M
. Repeat the steps
until the last digit on the right
is flashing. Confirm with
ODO BIKE 1/SET OK? Confirm with
M
.
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
Using
go to BIKE/SELECT
Confirm with
M
.
BIKE 1 (use
to switch to
bike 2). Confirm with
M
.
VDO CYCLECOMPUTING
BIKE 1 /SELECT OK? Confirm with
The display confirms BIKE/SELECT DONE
Automatic return to SETTINGS/SELECT
The selected bike 1 or 2) is
shown on the display bottom
left. (
)
.
M
5.6 Service interval display
The VDO service interval display reminds you to
have your bike checked in the workshop.
You can switch the service interval ON or OFF.
You can set separate service intervals for 2 bikes
When the set service interval distance has been
reached:
The
-symbol flashes on the display.
B
The information line displays
B
BIKE SERVICE/BIKE 1
You should now either carry out the
recommended bike check yourself or
have the bike checked by your dealer.
Press any button. The text BIKE SERVICE
disappears again. After another 50 km
the
also disappears. You can also switch
off the flashing
-symbol.
To do so, enter the service interval again.
www.vdocyclecomputing.com
M
.
ATTENTION, important note: When switching
from bike 1 to 2 or vice versa, the data for day's
tripdistance, ride time, average speed and max.
speed for the last trip are set to zero.
How to set the service interval:
Using
SELECT. Confirm with
You are now in setting mode
(pressing
you back to function mode).
Using
SET. Confirm with
BIKE SERVICE/ON (switch to OFF
using
JP
PL
SLO
GB
go to SETTINGS/
M
.
for 3 seconds gets
C
go to BIKE SERVICE/
M
.
). Confirm with
.
M
X1
15
Advertisement
Table of Contents
