Side Stand Removal - MV Agusta F4 S Workshop Manual

SIDE STAND REMOVAL

If the side stand needs to be replaced, use the follow-
ing procedure:
Place the motorcycle on the rear stand (special tool).
Special tool No. 800092642
Remove the side fairings and the underfairing as
described in the chapter "Superstructures."
Disconnect the electrical connector of the safety
switch.
Remove the side stand safety switch by unscrewing
two screws (1) indicated in the figure.
Release the two springs.
Remove the nut located behind the stand mount.
Remove the screw (2).
If the stand plate needs to be removed, remove the
three fixing screws (3).
For reassembly, proceed in the reverse order of
removal.
Apply the recommended thread-locking liquid to the
three plate fixing screws.
Tighten to the prescribed torque pressure.
Tightening torque for the stand plate screws (3):
23 ÷ 25 N·m
Recommended thread-locking liquid:
Loctite 243
Tightening torque for the stand nut (2): 25 N·m
Side stand (1) switch screw tightening torque:
5 ÷ 7 N·m
Recommended thread-locking liquid:
Loctite 243
The springs must be removed with a special-
ly designed tool.
Before reattaching the springs, ensure that
the stand can swing freely (with no friction or
sticking).
Frame
5÷7 N•m
23÷25 N•m
- 7 -
1
2
25 N•m
3
3
G
2