Measure the DC voltage between the positive (+) and
the negative (-) terminals of the battery with a multi-
tester. If the tester indicates less than 12.6V or more
than 14.5V the cause will be found in the generator.
When carrying out this check, ensure that
NOTE
the battery is fully charged.
Feed charge
Standard: 12.6V – 14.5V at 2000 r.p.m.
STARTER SYSTEM
The diagram below represents the starter system.
START SWITCH
Electrical system
CLUTCH LEVER
RUN
PULLED
RUN
PULLED
RUN
PULLED
GEAR POSITION
STAND POSITION
NEUTRAL
NEUTRAL
ANY
- 21 -
Battery
UP
DOWN
UP
E