Engine Assembly On The Frame - MV Agusta F4 S Workshop Manual

Use the crank to free the engine.

ENGINE ASSEMBLY ON THE FRAME

Preliminary wiring positioning operations on the
engine (F4 S - FT - RR)
To facilitate reassembly, before repositioning the
G
engine on the vehicle, perform the following cable and
tubing positioning checks.
- Make sure that alternator and gear sensor connectors
are in position (A).
- Make sure that the coil cables are positioned between
the suction manifolds (1-2) and (3-4).
- Make sure the solenoid valve suction tubes (B) and
the phase sensor (C) are fitted behind the suction
hoses.
- Make sure the rev sensor cable (D) is wound togeth-
er with battery and ground cables (E).
- Make sure there are three rubber caps on the engine,
two on the cylinder flute (F) and one on the blow-by
cover (G).
- Check the proper passage of the TSS closing tube
(H).
Frame
H
F
A
- 64 -
C
1
2
3
4
B
G
D
E